Single line lubrication system: Principle: There is only one main line, usually injected with lubricant by a plunger pump in to the main line, and directly distributed to each lubrication point through a single line oil feeder. After the plunger pump stops working, the single line oil feeder resets, the return valve opens, and some of the grease in the pipeline is returned to the oil barrel of the plunger pump. कदा संविधानसंविधानसंविधिं प्रयोगश्चित्ता नि, शीर्षकं निर्विधानसंविधानं तेल संविधानसंविधानसंविधानसंविधानसंविधानसंविध

 

 

 

singular
माडले	QRH-2	rated voltage	DC24V/AC220V/AC380V
nominal pressure	31.5Mpa	capacity	6/8/10/12/16L
जालसम्पर्कः	10/30/235 सम्पूर्ण ml/min	नियन्त्रणबिन्दुकाः	घट्टाम् 1-50
Distance	1-30 meters	protection grade	Address
operation temperature	-30 + 85℃	भंग्रणस्थानम्	-40 + 85℃
क्रियालनम्बनम्	10% इतीदम् 90%	भंग्रणस्थानम्	5% इतीदम् 90%
युक्रमणं विस्तीरणम्
Suitable for thin oil, NLGI 2 # and below oils, and can be used for NLGI 3 # oils under specific conditions (such as high temperature).
सारणबिन्दुवाक्षस्थिति विच्छेदना
Monitor the oil output signal of each lubrication point
कार्य्यम् (विकल्पिक)
■ Network detection ■ Large capacity ■ Single fuel supply time control ■ Single fuel supply quantity control
कार्यभिव्यापनम्
अङ्केतः संविधायं lubrication-अङ्केतः सम्पूर्णं नियंत्रणायं कर्तयं त्रुटिं नीतृत्यं कर्तयं तीर्णसंविधा। प्रत्येकः lubrication-अङ्केतः bloक्तयं कर्तयं मनुष्ययन्त्रम्।
अनुप्रयोगः
Lubrication points are relatively few and concentrated within a small radius, and lubrication sites with strict oil supply requirements
अनुप्रयोगस्योगः
Mining machinery, engineering machinery